In agriculture and gardening, row cover is any transparent or semi-transparent flexible material, like fabric or plastic sheeting, used as a protective covering for plants, usually vegetables. Covers are used to extend growing seasons, and reduce undesirable effects of cold, wind and insects.[1] Row covers can reduce the drying effect of wind, and can provide a small amount of warming in a similar way to unheated cold frames, greenhouses and polytunnels, creating a microclimate for the plants.
The first commercial-scale use of polyethylene row covers in the US was in the 1950s, and by the 1980s their use was widespread.[1]
Row cover is a lightweight synthetic, such as clear plastic (polyethylene) or spunbonded polyester called horticultural fleece. Plastic covers are elevated above plants on a supporting framework such as wire hoops to form a low tunnel. (Plastic placed directly on the ground is mulch.) Fleece covers can be placed directly on plants or on supporting frames. Floating row cover is the term used when there are no (or minimal) supports under the fleece and the plants themselves hold up the fleece, though the edges may be anchored to the ground against wind by metal staples or soil piled up over the edges.[1]
All row cover materials reduce the amount of light reaching the plants by a small amount (for example, 10%–20%), but such materials do not reduce sunlight in the way shade cloth does (50%–95% shading). Commercial products are marketed describing the percentage of light reduction.[1]
In hot weather, plastic covers need to be vented to prevent heat-buildup or too much moisture under the cover, and may have built in vent holes. Fleece material is self-venting and will allow water and rain to penetrate the cover.[2]
Row covers provide better frost protection in the fall than spring because the heat built up in the soil over summer will help to raise the temperature a few degrees under a cover. Fleece covers can protect against certain destructive insects but must be removed when the crop is flowering if insect pollination is required.[3]
YouTube Encyclopedic
-
1/3Views:11 27896528 991
-
How to install row covers on vegetable crops
-
Using a Row Cover to Protect Your Garden - "Duck and Row Cover"
-
Mary's Garden: Low Tunnel Row Cover & T-Frame Arch Installation
Transcription
[music] [Mark Zumwinkle, soil scientist, Minnesota Department of Agriculture]: The water gently goes in there’s no erosion because it slows the rain down into a soft spray. It prevents evaporative loss from the soil, almost completely. So, a dramatic increase in water use efficiency and then let’s take a look here, because if you see that there, it’s starting to dry out a little bit. If you come in here look at this…see how moist that is? And cabbage is a heavy water feeder. So if they were to have drought stress, this would dramatically outperform. Absolutely. Well here we have beautiful cabbages here. [Annalisa]: Any insects? [Mark]: No damage, zero. You have to get these on right away. If you wait one or two days then you can trap insects inside of there. [music]
See also
References
- ^ a b c d George J. Hochmuth; Robert C. Hochmuth; Steve Kostewicz & William Stall (1987). "Row Covers for Commercial Vegetable Culture in Florida". Institute of Food and Agricultural Sciences (University of Florida). Retrieved 19 March 2015. Article marked reviewed by publisher in 2012.
- ^ Fleece and crop covers by Royal Horticultural Society
- ^ Community Garden Guide : Season Extension : Floating Row Cover by Natural Resources Conservation Service
This page was last edited on 18 March 2024, at 23:03