Panzerbüchse 39

Panzerbüchse 39
A Wehrmacht soldier with PzB 39 in Northern France
Type	Anti-tank rifle
Place of origin	Nazi Germany
Service history
In service	1939–1945
Used by	Nazi Germany
Wars	World War II
Production history
Designer	B. Brauer
Designed	1939
Manufacturer	Gustloff Werke
Produced	1938–1941
No. built	1408 (PzB 38) 39 232 (PzB 39)
Variants	Granatbüchse 39
Specifications
Mass	16.2 kg (35.71 lb) (PzB 38) 12.6 kg (27.78 lb) (PzB 39)
Length	1,620 / 1,280 mm (63.8 / 50.4 in) (folded for transport)
Barrel length	1,085 mm (42.7 in)
Cartridge	7.92x94mm Patronen
Caliber	7.92 mm
Action	Falling-block action
Rate of fire	10 rounds/min (practical rate)
Muzzle velocity	1210 m/s[1]
Effective firing range	300 m (330 yd) (for penetration of 25 mm armor)[1]
Feed system	Single shot
Sights	Hooded front post, rear "V" notch

The Panzerbüchse 39, abbreviated PzB 39, (German: "tank hunting rifle model 39") was a German anti-tank rifle used in World War II. It was an improvement of the Panzerbüchse 38 (PzB 38) rifle.

Development

PzB 38

German anti-tank rifles originated back in 1917 with the Mauser 1918 T-Gewehr, the world's first anti-tank rifle, using a special 13.2 mm (0.52 in) cartridge. It was created in response to the appearance of the first British tanks on the Western Front. That single shot manually operated rifle enjoyed moderate success; approximately 15,800 rifles were built.

German development resumed in the late 1930s. In an effort to provide infantry with a man-portable lightweight anti-tank rifle, Dipl.-Ing. (certified engineer) B. Brauer at Gustloff Werke in Suhl designed the Panzerbüchse 38 (PzB 38). It was a manually loaded single-shot weapon with a recoiling barrel, using a special 7.92 mm (0.311 in) cartridge. When fired, the barrel recoiled about 9 cm (3.5 in), which opened the breech and ejected the spent cartridge casing. The breech block was then arrested in the rear position, remaining opened for the gunner to manually insert a new cartridge. The gunner then released the cocked breech with a lever at the grip. The breech and barrel would then move forward again and the trigger was cocked in preparation to fire. This rather complicated mechanism was reportedly prone to jamming as the system got dirty in field use.

Although manufactured with pressed steel parts that were spot-welded, because of the complicated vertical breech block mechanism it was difficult to manufacture and only a small number of 1,408 PzB 38 rifles were built in 1939 and 1940 at the Gustloff Werke plant; 62 of these weapons were used by German troops in the invasion of Poland in 1939.

The rifle was 161.5 cm (5 ft 3.6 in) long - 129.5 cm (4 ft 3.0 in) folded for transport - and weighed 15.9 kg (35 lb).^[1][2] It used a specifically designed cartridge with a standard caliber of 7.9 mm, but a very large 94 mm long case (nominal 7.92×94mm).^[3] also known as the "7.92 x 94 Patronen".

PzB 39

The next development, onto which production was immediately switched, was the Panzerbüchse 39 (PzB 39), an improvement made by Gustloff on their PzB 38. It also used a vertical breech block mechanism and the same cartridge as the PzB 38. It retained the barrel of the PzB 38 and had an only slightly increased overall length of 162.0 cm (5 ft 3.8 in); weight was reduced to 12.6 kg (28 lb). Performance was basically the same as that of the PzB 38. To increase the practical rate of fire, two cases each containing 10 rounds could be attached to the sides of the weapon near the breech - these were not magazines feeding the weapon, but merely put the cartridges closer to hand for the gunner. 568 PzB 39 were used by the German army in the invasion of Poland; two years later, at the beginning of Operation Barbarossa, 25,298 PzB 39 were in use by German troops. Total production from March 1940 to November 1941, when production ceased, was 39,232 rifles. The PzB 39 remained in use until 1944, by which time it had become hopelessly inadequate against all but the lightest armored vehicles.

Variants

Starting in 1942, remaining PzB 39 rifles were rebuilt with a shortened barrel (590 mm) and an affixed Schiessbecher ("firing cup") attachment threaded to the barrel and used to launch standard rifle grenades. The cup was the standard type used with the ubiquitous Kar 98k infantry rifle and the ammunition was also interchangeable; there were three types of grenades: an anti-personnel grenade, a light anti-tank grenade and a large-diameter anti-tank grenade. The grenades were propelled by a special cartridge with a wood bullet. The rifle was also outfitted with a special sighting arrangement for firing up to 150 m and the wooden forend was removed. These converted rifles received the designation Granatbüchse Modell 39 (GrB 39) and remained in use until the end of the war.

See also

• Anti-tank rifle
• Boys anti-tank rifle
• Lahti L-39
• Mauser 1918 T-Gewehr
• PTRD-41 ― Mass produced competing design to the PTRS
• PTRS-41 ― Mass produced competing design to the PTRD
• Solothurn S-18/100
• Type 97 automatic cannon
• Wz. 35 anti-tank rifle

References

External links

• Small Arms Review
• Anti-Tank Rifle History and Collecting
• An Introduction to Anti-Tank Rifle Cartridges
• Forgotten Weapons - Panzerbüchse 39 German Anti-Tank Rifle

This page was last edited on 11 February 2024, at 16:53