DSL Rings (DSLR) is a telecommunications technology developed by Canadian start-up Genesis Technical Systems, based in Calgary, Canada. The DSL technology re-uses existing copper telephone network cabling to provide a stated bandwidth of up to 400 Mbit/s.[1][2] The technology also includes quality of service (QoS) and efficient multicast.
Genesis reported that two unnamed European telecom providers began testing the technology in July 2010.[1]
YouTube Encyclopedic
-
1/3Views:949976334
-
DSL Rings demonstration at Broadband World Forum
-
DSL Rings - Superfast Broadband for Rural Communities
-
Genesis launches DSL Rings, Superfast Broadband (up to 400 Mb/s) over copper
Transcription
Technical overview
DSL Rings technology combines the capabilities of VDSL2, DSL bonding, Resilient Packet Rings (RPR) technologies and add-drop multiplexers (ADM) in a collector ring instead of the historic tree and branch approach.
The links between the houses are implemented via passive jumper wires that do not come back to the Convergence Node (CN). Thus, a single CN design can efficiently manage 2–16 houses in a given ring. Genesis suggests a maximum of 16 houses in the ring due to the delay introduced by transiting each node to get back to the central office (CO); however RPR has an upper limit of 255 nodes in a ring.
Bonded pairs are used to obtain maximum bandwidth from the CO to the pedestal (DP). The Convergence Node, which is environmentally hardened and powered via the copper wire from the CO, terminates the bonded signals and acts as the gateway node for the subscriber 'collector' ring. DSL Rings technology is based on the Resilient Packet Rings (RPR) protocol. The technology enables a fail-safe in that, if a single pair is cut, the traffic goes in the opposite direction around the ring to get to the network gateway node. RPR also provides built in quality of service (QoS) for traffic differentiation and managed services as well as an Efficient Multicast (EM) capability that significantly reduces overall ring bandwidth requirements for multicast/broadcast video.
Within the DSL Rings architecture the bonded link to the CO/Exchange, which is typically a binder group (20–25 pairs depending on the telco), is terminated at the pedestal where a ring is initiated. DSL Rings provides the capability to both terminate the bonded link from the CO and initiate another bonded link towards another pedestal down the road.
References
- ^ a b Sturgeon, Jamie (October 18, 2010). "A smarter route to high-speed Net". Financial Post. Archived from the original on January 18, 2013. Retrieved December 11, 2012. Note: Genesis has posted corrections and clarifications to the Financial Post article here: http://www.dslrings.co.uk/the-national-post-a-smarter-route-to-high-speed-net/
- ^ "Telecoms New Dawn - Genesis Technical Systems launches DSL Rings® at Broadband World Forum 2012". PRLog. October 12, 2012. Retrieved February 14, 2014.
External links
This page was last edited on 2 March 2024, at 22:29