 AAUSAT-II, alongside its engineering model, ahead of launch | |
| Names | AAUSat-II Aalborg University CubeSat-2 |
|---|---|
| Mission type | Technology demonstration |
| Operator | AAU Student Space |
| COSPAR ID | 2008-021F |
| SATCAT no. | 32788 |
| Website | www |
| Mission duration | 6 months (planned) 4 years (primary) 15 years (ongoing) |
| Spacecraft properties | |
| Spacecraft | Aalborg University CubeSat-2 |
| Spacecraft type | 1U CubeSat |
| Bus | CubeSat |
| Manufacturer | AAU Student Space |
| Launch mass | 1 kg (2.2 lb) |
| Dimensions | 10 × 10 × 11.3 cm (3.9 × 3.9 × 4.4 in) |
| Start of mission | |
| Launch date | 28 April 2008, 03:53:51 UTC[1] |
| Rocket | Polar Satellite Launch Vehicle (PSLV-CA) |
| Launch site | Satish Dhawan Space Centre, Second Launch Pad |
| Contractor | Indian Space Research Organisation |
| Entered service | May 2008 |
| End of mission | |
| Disposal | Primary mission end |
| Deactivated | March 2012 |
| Orbital parameters | |
| Reference system | Geocentric orbit[2] |
| Regime | Sun-synchronous orbit |
| Perigee altitude | 615 km (382 mi) |
| Apogee altitude | 634 km (394 mi) |
| Inclination | 97.9° |
| Period | 97.4 minutes |
| Instruments | |
| Attitude Determination and Control System (ADCS) Gamma ray detector | |
AAUSAT-II (Aalborg University CubeSat no 2), is the second student-built CubeSat built and operated by students from Aalborg University in Denmark.[2] It was launched 28 April 2008 05:53:51 UTC from Satish Dhawan Space Centre in India on a Polar Satellite Launch Vehicle (PSLV) launch vehicle. AAUSAT-II carries a gamma radiation sensor.
YouTube Encyclopedic
-
1/3Views:1 9362 8552 001
-
AAUSAT II
-
Satellites in a box
-
12m Mesh Deployment
Transcription
Educational objective
The primary purpose of construction of satellites at the University of Aalborg is to give the students engineering capabilities beyond what is normally achieved within a masters program.
History
Student satellite activities at Aalborg University (AAU) started in 2003 as a result of AAU's involvement in the first pure Danish research satellite, Ørsted, which was successfully launched in 1999. AAUSAT-II's predecessor was AAU CubeSat which was constructed in the period 2001-2003 and was launched 30 June 2003. The project started in the summer 2003. The construction of AAUSAT-II began in 2005.
Operations
After the launch on 28 April 2008, AAUSat-2 beacon was received at Cal Poly University in California but two-way amateur radio communications could not be achieved as it turned out that AAUSat-2 was transmitting at a lower level than anticipated. After upgrades to the ground station were completed, fully functional two-way communication were achieved and continued with normal operations until May 2009 after a year of successful operation.
The ground station has remained in operation and beacons are received on a regular basis and AAUSat-2 is still considered operational - although heavy tumbling is observed (December 2009). Beacons are still received on regular basis in March 2011. In addition, AAUSat-2 does receive and acknowledge commands from ground and log files has been requested and received. Due to the very high tumbling (more than 2.5 Hz) it has not been possible to decode log files.
Below is a snapshot of the radio communication. On left side is a beacon, next a request for log is issued and AAUSat-2 reply with a transmission of the logfile. Notice the high tumbling rate.
In March 2012, the AAUSAT-II mission was officially retired by the project — but the CubeSat is still up and running. As of 2022, the satellite continues to function.[2]
Mission definition
AAUSAT-II consists of several sub-systems:
- ADCS: Attitude Determination and Control System
- CDH: Command and Datahandling System
- COM: Communication System
- EPS: Electrical Power System
- GND: Ground Station
- MCC: Mission Control Center
- MECH: Mechanical System
- OBC: On-board Computer System
- P/L: Payload System
Technical Facts:
| Dimensions | 100 by 100 by 113 millimetres (3.9 in × 3.9 in × 4.4 in) CubeSat standard |
| Mass | 750 grams (26 oz) |
| Expected lifetime | Minimum 1 month, extended until end of lifetime |
| Attitude determination system | Sun sensors, gyro sensors, magnetometers |
| Attitude control system | Momentum wheel and magnetic coils |
| Power | Solar-cell panels located in satellite surface |
| Batteries | Li-ion 8.2V 2200 mAh |
| Power bus | 3.3 and 5V regulated |
Amateur radio information
- Callsign: OZ2CUB
- Up/downlink: 437.425 MHz AFSK & FSK
- Bit rate: 1200-9600 bit/s (1200 as standard mode)
- AX.25 FM CW TLM
See also
References
- ^ McDowell, Jonathan. "Launch Log". Jonathan's Space Report. Retrieved 22 January 2014.
- ^ a b c "AAUSAT-II (Aalborg University CubeSat-2)". ESA eoPortal Directory. 2021. Retrieved 26 October 2021.
External links
This page was last edited on 1 October 2023, at 18:25