A touch hole, also known as a cannon vent, is a small hole at the rear (breech) portion of the barrel of a muzzleloading gun or cannon. The hole provides external access of an ignition spark into the breech chamber of the barrel (where the combustion of the propellant occurs), either with a slow match (matchlock), a linstock or a flash pan ignited by some type of pyrite- (wheellock) or flint-based gunlock (snaplock, snaphaunce, and flintlock), which will initiate the combustion of the main gunpowder charge.[1] Without touch hole, it would be nearly impossible to ignite the powder because the only otherwise access into the barrel is from the front via the muzzle, which is obturated by the projectile.
In the later caplock firearms, the ignition sparks are generated by a shock-sensitive percussion cap placed over a conical "nipple", which has a hollow conduit known as the flash channel, that leads into the barrel and serves the same function as the touch hole.
In modern breechloading firearms, the propellant charge is packaged inside a cartridge, which has a modified percussion cap (primer) seated in a cavity at the back end of the cartridge case. Between the primer pocket and the case chamber are one or more apertures known as flash holes, which serves functionally as a touch hole inside the cartridge.
In artillery, priming powder, a fuse, squib, or friction igniter is inserted into the touch hole to ensure ignition of the charge. The ignition might be achieved via striking or electrically.
YouTube Encyclopedic
-
1/3Views:7 84614 46053 560
-
Wall gun #18 Drilling the touch hole
-
Military heritage Indian muskets Review and flash hole drilling
-
Sharpening the gunflint
Transcription
Spiking the guns
Spiking a gun was a method of temporarily disabling a cannon by hammering a barbed steel spike into the touch hole; this could be removed only with great difficulty. If a special spike was unavailable, spiking could be done by driving a bayonet into the touch-hole and breaking it off, to leave the blade's tip embedded.[2] Guns could also be rendered useless by burning their wooden carriages or blowing off their trunnions.[3]
Count Friedrich Wilhelm von Bismarck, in his Lectures on the Tactics of Cavalry, recommended that every cavalry soldier carry the equipment needed to spike guns if an encounter with enemy artillery was expected.[4] If a cannon were in danger of being captured by the enemy, its crew would spike the gun to prevent it from being used against them. Captured guns would be spiked if they could not be hauled away and the gun's recapture seemed likely. Covert missions to spike the enemy's guns could also be done to prevent counterattacks and protect ships during withdrawal, as in the case of the Ranger's attack on Whitehaven during the American Revolutionary War.[citation needed]
References
- ^ Vauban and the French military under Louis XIV, Jean-Denis G. G. Lepage, p.38
- ^ Richard M. Lytle (1 January 2004). The Soldiers of America's First Army, 1791. Scarecrow Press. p. 101. ISBN 978-0-8108-5011-8.
- ^ Dewey Lambdin (1 April 2009). H. M. S. Cockerel. McBooks Press. pp. 279–. ISBN 978-1-59013-466-5.
- ^ Bismarck, Friedrich Wilhelm (1855). On the Uses and Application of Cavalry in War. London: T and W Boone. p. viii. Retrieved 13 September 2012.
translated by North Ludlow Beamish
This page was last edited on 25 May 2024, at 15:09