Mechanical testing

Mechanical testing covers a wide range of tests, which can be divided broadly into two types:

1. those that aim to determine a material's mechanical properties, independent of geometry.^[1]
2. those that determine the response of a structure to a given action, e.g. testing of composite beams, aircraft structures to destruction, etc.

Mechanical testing of materials

There exists a large number of tests, many of which are standardized, to determine the various mechanical properties of materials. In general, such tests set out to obtain geometry-independent properties; i.e. those intrinsic to the bulk material. In practice this is not always feasible, since even in tensile tests, certain properties can be influenced by specimen size and/or geometry. Here is a listing of some of the most common tests:^[2]

• Hardness Testing
  • Vickers hardness test (HV), which has one of the widest scales
  • Brinell hardness test (HB)
  • Knoop hardness test (HK), for measurement over small areas
  • Janka hardness test, for wood
  • Meyer hardness test
  • Rockwell hardness test (HR), principally used in the USA
  • Shore durometer hardness, used for polymers
  • Barcol hardness test, for composite materials
• Tensile testing, used to obtain the stress-strain curve for a material, and from there, properties such as Young modulus, yield (or proof) stress, tensile stress and % elongation to failure.
• Impact testing
  • Izod test
  • Charpy test
• Fracture toughness testing
  • Linear-elastic (K_Ic)
  • K–R curve
  • Elastic plastic (J_Ic, CTOD)
• Creep Testing, for the mechanical behaviour of materials at high temperatures (relative to their melting point)
• Fatigue Testing, for the behaviour of materials under cyclic loading
  • Load-controlled smooth specimen tests
  • Strain-controlled smooth specimen tests
  • Fatigue crack growth testing
• Non-Destructive Testing

References

General references

• Foster, P. Field (2007), The Mechanical Testing of Metals and Alloys, Read Books, ISBN 978-1406734799.
• American Society for Metals (2000), ASM Handbook Volume 8: Mechanical Testing and Evaluation, American Society for Metals, ISBN 978-0871703897.
• Fenner, Arthur J. (1965), Mechanical Testing of Materials (International monographs on materials science and technology), Newnes, ASIN B0000CMMOM.
• Foster, P. Field (2007), The Mechanical Testing of Metals and Alloys, Read Books, ISBN 978-1406734799.

This page was last edited on 21 October 2023, at 15:01